IDEX
Tough-to-remove supports leave a rough, bumpy finish. That's why the HSP1-I is equipped with an Independent Dual Extrusion (IDEX) system, allowing you to print complex geometries with water-soluble support material.
Reliability
The HSP1-I is simple to use and produces high-quality, high-precision prints. This machine utilizes high-performance, closed-loop stepper motors on all axes, even Z! The HSP1-I always knows where the motor position is, eliminating layer shifting. The Z-axis has Nema23 stepper motors with a 10:1 gearbox attached to large industrial ball screws.
For added consistency, the HSP1-I comes with slicer presets for Layer Line Filament, guaranteeing the best results every time.
-
Build Volume
X: 650mm / 26in
Y: 640mm / 25in
Z: 1,000mm (1 Meter) / 40in -
Machine Dimensions
X: 1,320mm / 52in
Y: 640mm / 35in
Z: 1,930mm / 76in(Fits through a 36" doorway!)
-
Electrical & Networking
Works with a standard 120VAC 15A Circuit (Grounded)
Full Industrial Breaker Protection
Networked with WiFi or Ethernet, and also works without being on a network
-
Electronics
Duet 3 Controller Platform
Open Source RepRap Firmware
Filament Detection & Clog Sensors
AC-powered bed heater, up to 110C with Integrated Thermal Fuse
Closed-Loop Stepper Motors on all 3 axes (X, Y, and Z)
High Precision Bed Level Sensor
Independent Tilt and Mesh Bed Leveling
Open Slicer Compatibility - Use Whatever Slicer You Want
Material Profiles to be provided for select slicers
Dual Screens for both local direct control and the web interface without requiring a separate laptop
-
Mechanical
Print Resolution: >50 microns
Print Speeds up to 300mm/s, Travel Speeds up to 800mm/s
Z-Axis Driven by 4 Independent Ballscrews with a 10:1 Gearbox
X and Y Axes Driven by High Speed GT2 belts
Linear Rails on X, Y, and Z axes
Independent Dual Extrusion (IDEX) on Y-Axis
1/4" MIC-6 Aluminum Print Bed
Removable Magnetic Flex Plate with Textured PEI Print Surface (Other Surfaces Available)
Integrated Dual 10kg Spool Holders
Industrial Casters with Leveling Feet
-
Printheads
Dual Printheads, Independently Controlled (IDEX)
1.75mm Diameter Open Filament Compatibility - Use Whatever Materials You Want
Bondtech LGX Pro Extruders
Dual Takoto HE20 Hotends with Maximum Flow Rate of over 20mm3/s
Abrasion-Resistant Nozzles (0.60mm Nozzle Size By Default)
Dual 50-Watt Industrial Heaters, For 100 Watts of Total Heating Power per Printhead